BRIGHT X602 - Advanced Cleaning and Connectivity; Wall and Spiral Cleaning Modes; App Installation and Account Setup; Connecting the Robot to the App

EN
45
Wall following
Select mode “Wall Follow cleaning” in the app
on the phone. The vacuum cleaner vacuums
along walls and round obstacles. Run mode
remains active until it is changed manually.
Wall following can be activated in automatic
mode.
Spiral vacuum cleaning
Select mode “Spiral cleaning” in the app.
The vacuum cleaner starts from its position
and moves in an increasingly larger spiral.
When the vacuuming is completed, the
vacuum cleaner stops and automatically goes
into standby mode. Manual intervention is
required to continue. Run mode remains
unchanged if it is not changed manually.
FIG. 3
INSTALL APP
3. Scan the QR code to download the Smart
Life app. Or search at App Store or Google
Play.
FIG. 4
4. Start the app to register, or log into your
account.
Registration
Registration can be done using a mobile phone
number or an email address. *Country-specic
settings follow the mobile phone system, but
it is possible to manually change the country
code/country settings before completing the
registration (after completing the registration,
changes cannot be made).
Log in
If you already have an account, click on 'Log
in with an existing account' under 'Create a
new account', enter the mobile phone number
or email address used for registration and
enter the password to log in, after which the
iOS operating system can use the Apple ID for
login.
CONNECT PRODUCT
1. Press the "+" in the upper right corner
to add the vacuum cleaner under "Small
devices".
FIG. 5
2. Select WiFi network, enter the password
and click on “Next” to conrm the
connection.
3. Press the intermediate charging button
for 3 to 5 seconds. The status light ashes
rapidly and when the button is released
an audio prompt is given to indicated that
connection to the network is possible.
Check that the status light ashes rapidly
and conrm by clicking on “Conrm that
status light is ashing rapidly” to add the
device.
FIG. 6
4. Connection when the status light ashes
rapidly: Press the start button on the
vacuum cleaner for 3 to 5 seconds.
Release the button when an audio signal
is heard. When the status light on the
vacuum cleaner is ashing rapidly, click
on "Conrm that status light is ashing
rapidly" and enter the WiFi password.
Click on “Conrm” to conrm. The
vacuum cleaner goes into standby mode.
Repeat the above steps if a Connection
Failed message is displayed on your
phone.
FIG. 7
5. Connection when the status light ashes
slowly: If it is not possible to connect the
vacuum cleaner when the status light
ashes rapidly, try connecting when it
ashes slowly. Press the upper right corner
of the screen in the app to switch to
hotspot connection (compatibility mode).