Programming instruction for the BRIGHTSTAR remote CR1
This remote is preprogrammed to operate the following brands with no set-up:
Most: GE, LG, Magnavox, Panasonic, Philips, Quasar, RCA, Samsung, Vizio and Zenith.
If you have one of these brands of TVs, just put batteries in and you are done.
If not, please follow the programming instructions below.
Please note that if you reprogram this remote it will only operate the one
brand you reprogrammed it for.
Reprogramming your Remote
1. Manually turn on the TV.
2. Press and hold the SET-UP and the ENTER key until the LED blinks and remains on, then release the
button.
3. Find your 3-digit code from the code table and enter it. After the code is entered the indicator
light will turn off and you are done.
NOTE: If the LED blinked rapidly when you entered the code you may have entered an invalid
code; recheck the code list and try again. Also if volume and channel functions do not work then
you do not have an exact code match and please try another code.
4. Enter your code here for reference …………
To return to Factory Setting (Pre-programmed for a specific brand)
1. Press SETUP and hold until LED stays on.
2. Press CC
Reprogramming your Remote using code search.
If the code for your TV is not listed or you cannot get the TV to respond try the following:
1. Turn on the TV.
2. Press and hold the SET-UP and the ENTER key until the LED blinks and remains on, then release the
button.
3. Press the channel [CH+] up button slowly over and over again (60 or more times) until the
channel changes. The LED will blink and then stay lit. If you bypass the code just press CH- key
to go backward through the library until the TV changes channels. Pressing CH+
changes direction to forward again.
4. Now press ENTER to lock in the code.
Code identification
1. Turn on the TV.
2. Press and hold the SET-UP and the ENTER key until the LED blinks and remains on.
3. Press the SET-UP key again and release.
4. Now press each number key slowly from 0 to 9 and when the light blinks that is the first digit
of your code. To find the next digit repeat step 4 again and when the light blinks you have
found the second digit. Repeat one more time to get the third digit.
Sleep mode
This remote has an internal timer so even if your TV does not have sleep feature, it will work.
1. Turn on the TV.
2. Press Sleep, if Sleep Timer message appears on TV screen then select amount of time by repeatedly
pressing Sleep key. You are done.
NOTE: If after pressing Sleep no display is observed on TV follow steps 3-6.
3. Press and hold the sleep key until the light blinks and stays on. Then release the key.
4. Choose the time between 01 and 99 minutes (two-digit number). The LED will blink and remain
off. The timer is now set.
5. The remote must be left pointing toward the TV so it can send the signal to shut the TV when the
time elapses. (Obviously, the signal cannot be blocked by anything or it will not work.)
6. To deactivate sleep mode either press the power key or press and hold the sleep key
To Next Page
Need help?
General
