GB
20
Fault Possible Cause Remedy
Contact specialist workshop/
service centre.
Toothed belt defect.The blade shaft does not rotate.
Check power is available.No power supply.Motor not running.
Retighten the bearing screws.
Have damaged parts replaced
by the specialised workshop/
service station.
Blade shaft damaged
(out-of-balance),
fixture at the bearings loose.
Erratic running,
the implement vibrates strongly.
Contact specialist workshop/
service centre.
Toothed belt jumps.Erratic running.
Tighten bolts. Contact specialist
workshop/service centre.
The motor screws, its fixture or the
blade shafts are loose.
Unusual noises,
the implement rattles.
A
Check each time you use
the equipment
Inspect the equipment each time
before you use it. Do not use the
equipment if safety devices (switch
handle, safety covers) and/or if
the cutting device is damaged or
worn. Never disable safety devices.
Check the work area before start-
ing work. Remove any foreign
bodies present (e.g. stones,
branches or bones). Check for
foreign bodies whilst working.
Always wear sturdy shoes and
long trousers when working.
Never work barefoot or when
wearing only light sandals.
Check the cutting tools regularly for
damage and have them repaired
correctly if necessary.
Only have cutting tools replaced
by Brill Service or your authorised
specialist dealer.
A
Use/
Responsibility
Make sure that there are no other
people (especially children) or
animals within or near the working
area.
Powered equipment can cause
serious injuries! You are respon-
sible for safety in the area where
you are working. Never start
the equipment whilst tilted – risk of
injury!
Always use the equipment solely
for the purpose described in the
operating instructions.
Only use this unit in daylight or
when the area where you are
working is lit by ample artificial
lighting.
Make sure that the air vents are
free of dirt.
Ensure that you are standing
safely and on firm ground, even
on a slope. Work at an angle to
the slope, never upwards and
downwards. Do not work on exces-
sively steep slopes. Be careful if
you change direction on a slope,
turn the machine round or draw
it towards you. Be careful if you
are going backwards, risk of
stumbling!
Only push the equipment at
walking pace.
Turn the motor off if the equip-
ment has to be tilted when trans-
porting it over surfaces other than
grass and if you are transporting
the equipment backwards and
forwards to the work area.
Never use the machine with
damaged protective devices or
without protective devices.
Disconnect all the cutting tools and
drives before you start the motor.
When starting or operating the
starter switch take care as stipulat-
ed by the manufacturer’s instruc-
tions. Ensure that your feet are far
enough away from the cutting tool.
When starting or switching on the
motor, the machine should not be
tilted unless the machine has to be
raised during the process. In this
case only tilt it as far as absolutely
necessary and only raise the side
away from you.
Do not start the motor when
you are standing in front of the
discharge duct.
Keep your fingers and feet away
from the cutting tool!
Never lift or carry a machine with
the motor running.
Each time you have to work on
the machine or leave it or top it up,
always switch off the motor.
If you strike an obstacle when
working, please disable the
machine. Unplug from the mains.
Remove the obstacle, check the
11. Instructions for correct use, safety instructions
To Next Page
Loading...
