Brinno ATH100 - ATH100 Installation and Operation; Camera Setup for Installation; Housing Insertion and Sealing; Starting Time Lapse Capture

Installation Instructions- TLC200 & ATH100 (Weather Resistant Housing)
I/O ports will ONLY ACCEPT the Brinno Motion sensor cord and the
Specify External Power Supply.
Close the Weather Resistant Housing (ATH100) door and
latch the buckles (Top and bottom).
4.
Make sure the I/O
door is sealed.
5.
3.
Insert the Time Lapse Camera (TLC200) into the Weather
Resistant Housing
(ATH100), conrming the waterproof
seal is aligned correctly.
Seal
1.
Turn on the Time Lapse Camera (TLC200) power.
Set up the time interval
for image capture, and
press OK to start.
6.
Set u
p
the time interval
f
or image capture, and
press OK to start
.
6.
Adjust the Time Lapse Camera (TLC200) lens, facing
directly forward.
2.