7
Install Lens & Camera
1. Remove the protective lm
from the peephole lens. Insert
it into the exterior side of
the drilled hole on the door.
2. For the 12mm Peephole (For most North American users.)
Position the Peephole barrel through the washer into the base
ange from inside of the door. Tighten it.
For the 14mm Peephole
Position the Peephole barrel into the base ange. Tighten it.
1
For the 1412 mm PeepholeFor the mm Peephole
3. Make sure the TOP icon is facing up.
3
2
To Next Page
Loading...