LYNX
TM
Quick Start Instruction Manual
DEU—Schnellstart-Bedienungsanweisung
ITA— Manuale di istruzioni per l’avvio rapido
FRA—Manuel de démarrage rapide
ESP—Manual de instrucciones de inicio rápido
JPN—クイックスタート取扱説明書
CHN—快速入门使用说明书
© BriskHeat
®
Corporation. All rights reserved.
2
LYNX
TM
System Instructions
INTRODUCTION
Your LYNX Temperature Control System can supply a complete network of temperature control by providing each system with an Operator Interface
Panel and PID Control Modules for each heater. A LYNX Module is a compact controller that fits on to a LYNX Docking Station. The Docking Station
has wires that control power to the heater as well as a temperature sensor such as Type-J or Type-K thermocouples as well as PT100-RTD sensors.
This Quick Start manual is a simple guide for commissioning LYNX System hardware. If using without an Operator Interface, disregard those refer-
ences. For more detailed information, including commissioning with an Operator Interface and Modbus Registers, refer to LYNX Full Instruction Man-
ual 41295-10. Safety and Warning information is contained in manual 41295-09.
NOTE: READ ALL INSTRUCTION INFORMATION BEFORE ASSEMBLY, INSTALLATION, AND STARTUP.
To Next Page
General
