Need help?Do you have a question about the Bristol A Series and is the answer not in the manual?
Measure start winding current on start-up, typically 2 to 10 AMPS.
Check pull-down voltage before removing a suspect compressor.
Check run capacitor, start components, contactor, windings, grounding, and terminals.
Test LRPDV before removing compressor; voltage drop below threshold indicates issue.
Wire directly to compressor terminals to eliminate system variables for testing.
Ensure capacity, refrigerant, voltage, and frequency match the application.
Identify and repair the root cause of the previous compressor failure.
Mount compressor using provided grommets, avoid prolonged atmospheric exposure.
Detailed explanation of the compressor model number encoding system.
Measure start winding current on start-up, typically 2 to 10 AMPS.
Check pull-down voltage before removing a suspect compressor.
Check run capacitor, start components, contactor, windings, grounding, and terminals.
Test LRPDV before removing compressor; voltage drop below threshold indicates issue.
Wire directly to compressor terminals to eliminate system variables for testing.
Ensure capacity, refrigerant, voltage, and frequency match the application.
Identify and repair the root cause of the previous compressor failure.
Mount compressor using provided grommets, avoid prolonged atmospheric exposure.
Detailed explanation of the compressor model number encoding system.
General| Maximum Pressure | 175 PSI |
|---|---|
| Cylinder Arrangement | Vertical |
| Power Source | Electric |
| Pump Type | Cast Iron |
| Voltage | 230V |
To Next Page
