Brita On tap - Page 3

ENGLISH 3
1. Congratulations
Thank you for choosing BRITA quality for great tasting
BRITA filtered water. BRITA filtered water improves taste
of hot and cold drinks and is economical and convenient.
To ensure you achieve the best results, please read the
following instructions carefully before fitting the BRITA On
Tap water filter system to your tap.
2. Important notes
2.1 Ideal use
• Do not use any tools when installing the
BRITA On Tap water filter.
• Do not disconnect the BRITA On Tap
water filter system while running water
through the filter.
• Clean the outside of the BRITA On Tap water filter
system with a damp sponge and mild washing-up liquid.
Abrasive cleaners, detergents or chrome polish may
mark the finish.
• Do not put the BRITA On Tap water filter system or any
of its parts in the dishwasher.
• Should the BRITA On Tap water filter system require
repairs or servicing, do not attempt to disassemble the
unit. Please contact the BRITA Customer Service in your
country.
• For all notes on installation, operation and servicing,
please see the following sections of the instructions
for use.
2.2 Optimum performance
• The On Tap filter is designed for the use with cold tap
water. Please filter cold tap water only.
2.3 Filter first, and then boil
• The BRITA On Tap water filter system is designed to
be used only with municipally treated tap water. If an
instruction is received from the authorities that mains
water must be boiled, then BRITA filtered water must
also be boiled. When the instruction to boil water is no
longer in force, please clean the BRITA On Tap water
filter system thoroughly and insert a new cartridge.
• For certain groups of people (e.g. those with impaired
immunity and babies), it is generally recommended that
tap water should be boiled; this also applies to filtered
water.
2.4 Exclusion of liability
• BRITA cannot accept any liability if one does not follow
the given instructions of use.
3. Conditions for use
3.1 When does the BRITA On Tap filter not work?
The BRITA On Tap filter is not intended to be connected
to a low-pressure water heater; it is an external contact
system and its internal receptacle will not support the
pressure of the supply pipe.
The following characteristics will help you determine
whether your equipment is a low-pressure water heater:
!
A low-pressure water heater is
usually installed immediately next
to the sink or underneath it.
!
Low-pressure taps are fitted with 3
connections (open system).
1. Congratulations / 2. Important notes / 3. Conditions for use
1017032-00-ELA_OnTap_GA_Asia.indb 3 17.12.18 09:22