Brita On tap - Installation Prerequisites; Filter and Boil Instructions; Unit Cleaning Guide

4 ENGLISH
!
Hand tighten only. Do not use any tools when
attaching the diverter to the tap.
Step 3:
To remove the top cap (H) carefully turn the cap to the
right (see Fig. 3). Insert the supplied battery to the battery
mount. Reinsert the top cap and tighten it. The three lights
in the top cap will blink twice consecutively. The electronic
cartridge change indicator is now ready to go.
H
3
!
Always make sure that the BRITA logo on the
housing is facing downwards when connecting it to
the diverter (see Fig. 3 above).
4. Installation / 5. Initial operation
!
When the supply of hot water has been used
(between 5 and 10 litres), only cold water will come
out of the tap.
4. Installation
Step 1:
Remove the existing aerator (C) from the tap. The tap will
either have an external threat (Fig.1.A) or an internal thread
(Fig.1B).
C
1A
C
1B
Step 2 with external thread
Screw the diverter (A) onto the tap. No adapter is
necessary.
A
B
2A
Step 2 with internal thread:
To attach the diverter (A) to an internal thread you will need
to use the flat gasket (D) and adapter (E) which you will find
in the packaging. First insert the flat gasket into the internal
thread on the tap. Now screw the adapter to the tap, and
then screw the diverter (A) tightly onto the adapter.
D
E
B
A
2B
4. Installation
1017032-00-ELA_OnTap_GA_Asia.indb 4 17.12.18 09:22