4
PURITY C
1. The hose you need to ush the lter is located on the top of the lter.
It is grey in colour and about 10 cm long – see picture right.
2. The mechanism that controls the water being ushed is either a small round grey
button or a small grey slider and built into the top of the lter – see pictures below;
3. To ush the lter you must have a bucket and enough space next to the BRITA PURITY C
lter to be able to locate the bucket, so that it can sit at on the oor. If the lter is in
a cupboard you may need to lift the lter out of the cupboard in order to ush the lter
safely and so that the grey hose can reach the bucket. Be careful not to damage or
kink the water hoses when moving the lter from the cupboard.
4. The grey hose must be inside the bucket before you start the ushing procedure.
Also make sure that you are holding onto the ush hose before turning the water on,
as if the water pressure is too strong it may cause the hose to ip out of the bucket.
Grey hose
A. Sliding ush mechanism – Push the slider in the
direction of the arrow to start the ushing process,
to stop it ushing push it back in the other direction
B. Push button ush mechanism – Push button down
and hold it to ush, when you release the button it will
stop ushing
To Next Page
Loading...
