27
HOW TO INSTALL
10° to 15°
ANGULAR ADJUSTMENT OF RESTRAINT
Some vehicle seats have more rearward slope than others. If the angle of the seat causes the baby to be too
upright for comfort, the angle may be altered by placing a firm packing between the seat and the underside of
the base. Packing can be a firmly rolled up towel.
If the car's seat is too flat, some packing may be required at the front edge of the base to achieve the recline
angle.
Do not remove all of the installation angle by over packing. Always leave an angle of approximately
10°- 15°.
The stabilising bar does
not need to contact the
back of the car's seat,
provided the seatbelt is
tight. If desired this gap
may be packed.
BABY USE REARWARD FACING
To Next Page
Loading...
