31
PLACING CHILD INTO RESTRAINT (REARWARD FACING)
When positioning baby into the restraint make sure baby's
back is fully supported onto the flat section and the baby's
nappy area (bottom) is resting in the bottom curvature as
shown. It is recommended that bulky nappies are not used
when baby is travelling in the restraint as they can cause
incorrect positioning of the baby's back in the restraint.
A. Check that the harness shoulder straps are in the
correct position. Refer to pages 28 for correct shoulder
harness strap height and for setting up the harness.
B. Slacken the top tether strap if not already slack and
allow the straps to fall to the sides of the restraint for
easy access to the child.
C. Loosen shoulder straps by operating the harness
adjuster button or lever and pull both shoulder straps
evenly. Pull out the desired amount of slack.
D. Store buckle tongues on the buckle tongue holders while
placing baby in the restraint.
Pull Straps
Push harness
adjuster
button or lever
Buckle tongue holder on
both sides of the seat.
Push tongue inwards to
engage.
HOW TO USE
D
BABY USE REARWARD FACING
C
Bottom curvature
of child restraint
Flat section of
child restraint
To Next Page
Loading...
