To
4
rotect your child in a crash, you must use the Starriser to
ether
wtt seat belts that are compatible. Different vehicles have dr
4
erent
#oulder & lap) safety belts.
es of seat belts. The Starriser can only be used with three point
There are three point belts that will not work with the Starriser.
You cannot use the kind of seat belts where one or both of the
attachment points are motorized or installed in the vehicle door.
Use another seating position. As a rule, the rear seat is the preferred
seating position.
Make sure
the seat bets. Y
ou check the vehicle handbook for information on
WARNING!
Never use the StarriserKomfy with two point belts (lap belt or
shoulder belt onl
in case of a eras
i
) of any kind! The child could be seriously injured
This Restraint is not Certified for Aircraft use.
Aircraft seats have only two point seat belts.
Do Not place any child seat on front seat with airbag unless airba
is turned off-DEATH or SERIOUS INJURY can occur. The
bat &
seat is the safest place for children.
If you have any questions about what kind of belts you have in
your car, please return to the store where you purchased the
StarriserKomfy, and the store will be happy to hel
if the belts are compatible with the use of the
P
you determine
tarnser.
StarriserKomfy is only intended for use in vehicle seats that are
forward facin This restraint is not intended for use in seats that
are rearward acrng or side facing. Do not use it in such seats. f
5
WARNING!
Use the Starriser/Comfy in
vehicle seats which are forward
facing only!
Do not use on rearward-facing
or side facing vehicle seats.
You must use forward-facing
vehicle seats with this restraint.
Side-facing or rear-facing
vehicle seats in vans, station
wagons or trucks CANNOT be
used with this restraint.
The pur ose of the Starriser belt-adjustin booster seat is to adapt
the adu t webbing of the vehicle’s seat P
fY elts to the body size of
the child, so it is important to adjust the width correctly and to
use the height adjuster.
Adjusting Starriser. See illustration
1. The two armrests of the Starriser are
to be snug against the hips of the child,
so as to bring the lap belt close to the
body.
Illustration 1
To adjust the width of the
Starriser, see illustration 2. Loosen
the knob and pull the sides of the
booster apart. Make sure that the
cover holders are adjusted to the
new position.
As your child grows, you will have
to re-adjust the width of the
Starriser.
Illustration 2
Place the Starriser in the vehicle,
in a seating position with one
of the allowed three-point
safety belts. See illustration 3.
Make sure the shoulder belt
runs under the armrest nearest
the buckle and that the lap belt
runs under both armrests.
Find the shoulder belt adjuster
strap and attach it to the adult
shoulder belt. Simply thread the
adult webbing into the belt
guide clip. See illustration 4.
If the belt adjuster strap is too
long or too short, adjust the
length so that it fits snu
against the shoulder of t %
ly
e
chrld.
Britax Starriser Booster Seat Comfy Backrest page 2 of 4
To Next Page
Loading...
