EasyManua.ls Logo

Britax Roundabout - Page 52

Britax Roundabout
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Securing the Porsche Comfy sleep rest
The belt holder clip (fig. I, 7) on the Porsche Zoom must be
attached to the retaining bracket (fig. II, 5) of the sleep rest. To
do this, fold the Porsche Comfy sleep rest forward and attach belt
clip (fig. Ill, 7) to the retainin bracket (fig. Ill, 5). Now pull the belt
that the Porsche Comfy
Adjusting the height of the Porsche Comfy sleep rest
Undo the cover zipper, push in the “PRESS” button (fig. Ill, 31 and
lift the Porsche Comfy sleep rest lower bracket up and out of the
locking holes. Insert again at the required height (belt guide loop
at the height of the child’s shoulder (fig. IV)). Then push down
and slide the bracket until the lower bracket fingers engage the
sleep rest and the “PRESS” button (fig. fll,3) pops up and en
a hole in the lower bracket. Ensure that the lower brat
f
ages
et IS
securely connected to the back rest before zipping up the cover.
Securing the child
Place the Zoom and Comfy combination on the seat. Guide the
shoulder belt through the belt
child to make sure the shoul
d
uide loop (fig. IV, 6) and over the
er belt fits properly. Follow the
installation guidelines for the Porsche Zoom.
Removing the Porsche Comfy sleep rest
The snap wedges (Fig V, 9) must be removed first b
up and out. Then squeeze to ether the lower PRE
ulling them
k
iit buttons of
the plug-in connecbon (fig. I, 1) and at the same time lift the
Porsche Comfy sleep rest up and out.
PORSCHE
Sleep Rest
For Use with the Porsche Zoom Booster Seat
for Children from 37-100 Ibs
Britax Model 421-13
Porsche Comfy
Care and maintenance
Children
who have outgrown child seats often miss their lateral
support, particularly on tong journeys. The Porsche Comfy sleep
rest provide this comfort in conjunction with the Porsche Zoom
child booster seat. It has been tested and approved for use with
this system.
Remove the cloth
covering by unzipping and lifting upwards. Wash
carefully in a mild deter ent and warm water (30” C) and hang to
dry. Do
not
spin or machine dry.
WARNING!
Instructions on installation and use
Please read through these instructions carefully before using the
Porsche Comfy sleep rest. The Porsche Comfy sleep rest IS
sultable for children between the ages of 4 and 12 or weighing
between 37 and 100 lb (17 and 45 kg).
l
The Porsche Comfy sleep rest only provides effective
protection when it is used and installed properly in conjunction
with the Porsche Zoom booster seat in accordance with these
instructions and those for the Porsche Zoom booster seat.
The Porsche Comfy sleep rest should always be used In the car
on the rear seat (when possible) and in conjunctIon with a lap and
shoulder belt. It may also be used on the front passenger seat.
Please pay attention to the special notes when used In coqunchon
with a front passenger alrbag (see Porsche Zoom InstructIons and
your vehicle Owners Manual).
l
The Porsche Comfy sleep rest is designed, tested and
a proved in accordance with the requirements of US Federal
rir
otor Vehicle Safety Standard 213 governing child safety
devices.
l
If problems arise during use, please contact your Porsche
dealer.
Installing the Comfy sleep rest on
the Zoom booster seat
l
No modifications may be made to the Porsche Comfy sleep
rest.
Fold open the fabric tabs over the holes on the rear end of the
Porsche Zoom (fig. I). Lower the Comfy sleep rest so that the
plug-in connectors (fl
receptacles (fig. II, 2
7
II, 1) engage In the Zoom booster seat
and lock in position. “Locking in” of the
Comfy sleep rest may be enhanced by inserttng the snap wedges
along the plug-in connectors between the connectors and the seat
receptacles (fig. V, 9).
2
Britax
BRITAX Child Safety, Inc.
460-R Creenway Industrial
Drive
Fort
Mill, SC
29715
3
Porsche Comfy TM Sleep Rest page 1 of 2

Related product manuals