Britex romer DUALFIX PLUS - Settings; Adjust Headrest; Use the Insert for Newborn Babies

3 Settings
3.1 Adjust headrest
1
Adjustment ring
4
Adjustment button
2
Headrest
5
Shoulder pads
3
Harness buckle
6
Shoulder strap
1. Check that the headrest 2 is adjusted correctly.
If the shoulder straps are at or slightly above the
shoulder height of the child, the headrest is posi-
tioned correctly.
u
If the headrest is not positioned correctly, per-
form the following steps.
2. To loosen the belt, press the adjustment button 4 and
pull both shoulder straps 6 forwards at the same time.
The shoulder pads are not connected to the shoul-
der straps. If you pull on the shoulder pads, the
belt is not loosened. Only pull on the shoulder
straps.
3. Pull the adjustment ring 1 and slide the headrest 2 to
the correct shoulder height.
4. Check that the headrest 2 is locked correctly in place
by pushing the headrest 2 down.
P
Headrest 2 is adjusted correctly.
P
Headrest 2 is locked in place.
3.2 Use the insert for newborn ba-
bies
1
Loops
5
Harness buckle
2
Headrest
6
Padded crotch
3
Insert for newborn ba-
bies
7
Plastic hooks
4
Shoulder straps
WARNING
Risk of injury due to missing insert for newborn ba-
bies
The insert for newborn babies is an integral safety com-
ponent of the child seat. If the insert for newborn babies
is not used, this may lead to serious or even fatal in-
juries.
u
Use the insert for newborn babies if the for child is
between 40 and 60 cm.
u
Remove the insert for newborn babies if the child is
larger than 60 cm.
1. Open the harness buckle 5 by pressing the red button.
2. Place the insert for newborn babies 3 into the child
seat.
IP10036 | 1.3 | 2000036990 DUALFIX PLUS | BRITAX RÖMER 5