POWER SUPPLY
Parent unit and Baby unit
1. Operation from Ni-mH rechargeable battery
Press and slide open the battery door in direction as shown.
Insert the supplied Ni-mH rechargeable battery into the compartment. Observe correct polarities
indication.
2. Operation from AC mains using the intelligent rapid charger
Connect the output plug of the supplied 6V switching power supply to the DC jack of the rapid
charger, make sure the polarity is correct. With the unit being switched off, place it into the rapid
charger. The charging indicator will light up red green alternately while detecting the status
of battery. Adjust the position of unit in case the indicator does not light up. After 5 sec, the
charging indicator will start flashing red when the battery is under charging. Once the battery
is fully charged up (normally it takes around 4 hours), the charging indicator turns steady
green. Now the unit can be switched on for operation. Either you can take it out or keep placing
it in the rapid charger will cause no damage to the battery. In the latter case, when the battery is
being consumed and voltage falls to a certain level, the rapid charger will automatically start
charging up the battery again.
Note : Before using the unit for the first time, charge up Ni-mH battery with the rapid charger for
at least four hours. Be sure to switch off the unit before charging.
CAUTION : BE SURE THE BATTERY IN THE UNIT IS RECHARGEABLE
TYPE BEFORE PLACING IT IN THE RAPID CHARGER, OTHERWISE
EXPLOSION MAY RESULT.
BE SURE THE BATTERY IS INSTALLED IN THE UNIT BEFORE PLAC-
ING IT IN THE RAPID CHARGER, OTHERWISE THE UNIT WILL NOT
OPERATE NORMALLY.
26
27
27
27
TO AC OUTLET
To Next Page
Loading...