STANDARD ACCESSORIES
TROUBLE SHOOTING GUIDE
a.
b.
c.
d.
e.
f.
6V AC switching power supply for rapid charger x 2
Intelligent rapid charger x 2
Baby unit
Parent unit
3.6V Ni-mH rechargeable battery x 6
User manual
Problem Possible Causes Solution
Transmitter has no
transmission
Transmitter always on Mic sensitivity is too high Adjust mic sensitivity lower using
down button such that transmitter
become voice activated
Mic sensitivity is too low Adjust mid sensitivity higher using up
button
Recharge battery using charger
stand or check connection
Battery has run down or switching
power supply improperly connected
2
3
Out-of-range alarm
always on
Always showing low
battery alert
Battery life is short
Many static noise and
interference
Transmitter's battery has run down Recharge battery using charger stand
Pairing is not successful
Battery has run down Recharge battery using charger stand
No battery inside unit Put battery pack back into battery
compartment
Battery pack is damaged
Night light is permanently switched on Switch off night light
Vibration alert is switched on Switch off vibration alert
Transmitter is located near other
electrical appliance
Remove the electrical appliance or
re-locate the transmitter far away
from source of interference
Too short
communication range
Many steel structures between baby
and parent unit
Re-locate baby & parent unit
Baby unit battery has run down Replace with new battery pack or use
switching power supply
Replace with new battery pack
Perform pairing again
Distance between transmitter and
receiver exceeds the operating range
Move the transmitter and receiver
closer together
Distributor: Speli Baltic Ltd, Estonia. Tel. +44 1614080081; info@brittonbaby.com
b
a
c
d
e
f
To Next Page
Loading...
