Brivis RG36F/BGCEF User Manual

Dehumidifying operation
Ensure the unit is plugged in and the power is
turned on. The OPERATION indicator on the
display panel of the indoor unit will start flashing.
1. Press the button to select DRY mode.MODE
2. Press the buttons to set theUP / DOWN
desired temperature. The temperature
can be set within a range of 17 C~ 30 C
O O
in 1 C increments.
O
3. Press the button to start the airON / OFF
conditioner.
In Dehumidifying mode, you can not control the indoor
fan speed. It is automatically controlled by the unit.
NOTE
Adjusting air flow direction
3
1
2
2
TURBO
SELF
CLEAN
SLEEP
FRESH
SILENCE
TIMER
ON
TIMER
OFF
LOCK
RESET
LED
FOLLOW
ME
FAN
SPEED
SWING
MODE
TEMP
SWING
TURBO
SELF
CLEAN
SLEEP
FRESH
SILENCE
TIMER
ON
TIMER
OFF
LOCK
RESET
LED
FOLLOW
ME
FAN
SPEED
SWING
MODE
TEMP
SWING
Use the SWING and SWING buttons to adjust
the desired airflow direction.
1. Press the SWING button, and the horizontal
louver changes 6 in angle for each press.
0
Press and hold for more than 2 seconds, and the
louver will automatically swing up and down.
2. Press the SWING button, and the vertical
louver changes 6 in angle for each press.
0
Press and hold for more than 2 seconds, the
louver will automatically swing left and right.
When the horizontal / vertical louver swingNOTE:
moves to a position which may affect the
cooling or heating performance of the air
conditioner, it may automatically change
the horizontal or vertical position.
Timer operation
Press the TIMER ON button to set the auto-on
time of the unit. Press the TIMER OFF button
to set the auto-off time of the unit.
1. Press the TIMER ON button. The remote
control will display TIMER ON, the last Auto-on
setting time and the signal "H" will be shown in
the LCD display area. Now the unit is ready to
reset the Auto-on time to the start time.
2. Push the TIMER ON button again to set the
desired Auto-on time. Each time you press the
TIMER ON button, the time increases by half an
hour between 0 and 10 hours and by one hour
between 10 and 24 hours.
3. After setting the TIMER ON function there will be
a one second delay before the remote control
transmits the signal to the air conditioner. Then,
after approximately a further 2 seconds, the signal
"H" will disappear and the set temperature will
re-appear in the LCD display window.
To set the Auto-on time.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote
control shows TIMER OFF, the last Auto-off
setting time and the signal "H" will be shown in
the LCD display area. Now the unit is ready to
reset the Auto-off time to the stop time.
2. Push the TIMER OFF button again to set the
desired Auto-off time. Each time you press the
button, the time increases by half an hour
between 0 and 10 hours and by one hour
between 10 and 24 hours.
3. After setting the TIMER OFF function there will be
a one second delay before the remote control
transmits the signal to the air conditioner. Then,
after approximately a further 2 seconds, the
signal "H" will disappear and the set temperature
will re-appear in the LCD display window.
1
2
ON/OFF
ON/OFF

Brivis RG36F/BGCEF Specifications

General

Brand	Brivis
Model	RG36F/BGCEF
Category	Remote Control
Language	English