Broan 655C - Final Assembly and Light Installation; Wiring and Heater Assembly Reconnection; Light Reflector and Lens Installation

RED / ROJO
WHITE
BLANCO
BLACK
NEGRO
120 VAC LINE IN
LINEA DE ENTRADA DE 120 VCA
LIGHT
LUZ
VENT
RESPI-
RADERO
HEAT
CALOR
GROUND
TIERRA
RED
ROJO
BLACK
NEGRO
GROUND
TIERRA
RED
ROJO
BLUE
AZUL
WHITE
BLANCO
BLACK
NEGRO
2
3
1
THREADED ROD
LIGHT
ACORN NUT
GRILLE
USE THIS HOLE
BOTTOM VIEW
13. Wire unit according to wiring diagram. (See NOTE.)
14. Replace heater assembly removed in STEP 3 and plug it into
RED receptacle. Direct wires away from blower inlet.
15. Replace fan assembly removed in STEP 5 and plug it into BLACK
receptacle.
CAUTION
To avoid the possibility of overheating and/or fire, the grille
must be installed as shown. Acorn nut must attach to
threaded rod through proper hole in light reflector.
16. Slide the light reflector into opening in grille and plug into WHITE
receptacle. Use acorn nut from plastic bag to attach grille re-
flector assembly to threaded rod on housing. Tighten securely
using pliers or nut driver. Install a light bulb 100 Watt maximum.
17. Install light lens by 1) hooking one of its tabs into notch in grille/
reflector assembly; 2) apply light pressure to other tab with
fingertips and 3) snap into place.
3
Installation work and electrical wiring must be done by a
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and
standards.
RED