Broan QS330BL - Installation Preparation; Prepare Hood Location

B IiiiI
ALLURE ® QS3 SERIES
RANGE HOOD
PREPARE HOOD LOCATION
Page 2
PREPARE HOOD LOCATION
E]
ROOF CAP 3¼" X 10" or
7" ROUND DUCT
(For vertical
HOUSE WIRING
or Back of hood)
t
24" - 30" ABOVE
COOKINGSURFACE
3¼"X 10" DUCT
(For horizontal discharge)
Determine whether hood will discharge vertically (3W' x 10"
or 7" Round), or horizontally (3W' x 10" only). For vertical or
horizontal discharge, run ductwork between the hood location
and a roof cap or wall cap. For best results, use a minimum
number of transitons and elbows.
El Use for of ductwork and
diagrams, below, placement
proper
electrical cutout in cabinet or wall. For a non-ducted installa-
tion, DO NOT cut a duct access hole.
31A'X 10"
HOOD MOUNTING SCREWS (4) VERTICAL DUCTING
WOOD SHIMS
(recessed-bottom
cabinets only)
1315/16'' (30" hood)
1615/16'' (36" hood) 1315/16'' (30" hood)
1915/16"(42" hood) _ _ 1615/16"(36" hood)
1- CABINET FRONT 1915/16'' (42"hood)
1 1
_1 CABINET BOTTOM
I _--5¼".-, _--5 ¼':-,.
i,:1 _ VERTICALDUCT . 2"
:,1 _" ,I, ACCESS HOLE _ /i(
_i__ 11/, I
t t ELECTRICAL t
ACCESS HOLE
CENTER (in cabinet bottom)
LINE
"11½___LL
WOOD SHIMS j 31A'' X 10" J
(recessed-bottom HORIZONTAL DUCTING
cabinets only)
CABINET FRONT
I 1/8, , _"
MOUNTING
SCREWS (4)
7" ROUND i
HOOD MOUNTING SCREWS (4) [VERTICAL DUCTING
1315/16 '' (30" hood)
1615/16" (36" hood) 1 315/16" (30" hood)
(42" hood) (36" hood)
f" CABINETFRONT
CABINET l
BOTTOM
ACCESS HOLE ! 0V2"
FOR 7" ROUND
DUCT
WOOD SHIMS _ ELECTRICAL
ACCESS HOLE
(recessed-bottom CENTER (in cabinet bottom)
cabinets only) LINE
Run house wiring between service panel and hood location.
PREPARE THE HOOD
7" ROUND
DUCT PLATE
\
El Remove 7" Round Duct Plate from of hood. Set duct
top
plate aside - with mounting screws.
FILTERS
Remove Filters in Pull down filter
tape holding place.
on
tabs or finger holes and lift filters out. Set filters aside.