To Next Page
J
Jesus SweeneyAug 16, 2025
Why is there uneven oxygen flow in my Broco Prime-Cut Cutter?
- TTony MitchellAug 16, 2025
Uneven oxygen flow in your Broco Cutter can stem from a dirty or worn flash arrestor, a dirty or worn flash arrestor screen, or a dirty torch. To address this: * Inspect and clean or replace the flash arrestor. * Clean or replace the flash arrestor screen. * Clear the oxygen path by depressing and releasing the oxygen control valve lever with the torch connected to an oxygen source. Then, reinstall the flash arrestor and screen.
General
