What to do if I smell gas from my Bromic Heating Heater during combustion?
If you detect a gas odor while your Bromic Heating Heater is in use, it could be due to foreign matter in the gas or on the burner ports, the heater burning vapors from paint or impurities in the air, or a gas leak. You should ventilate the room and stop storing or using odor-causing products near the heater.
Why is my Bromic Heating Heater making a whistling noise when the burner is lit?
A whistling noise from your Bromic Heating Heater when the burner is lit could be due to blocked air passageways or air in the gas line. Operating the burner for approximately another 3 hours may resolve this issue.
Why is my Bromic Heating Heater emitting smoke and odor during initial operation?
The slight smoke and odor during the initial operation of your Bromic Heating Heater are likely due to residues from manufacturing processes. This should stop after approximately 3 hours of operation.
Why does the pilot light on my Bromic Heating Heater go out when I release the PILOT/IGN button?
The pilot light on your Bromic Heating Heater might extinguish when the PILOT/IGN button is released for several reasons: * The button may not have been pressed long enough; after the pilot lights, keep the PILOT/IGN button pressed for approximately 30 seconds. * The ODS safety feature may have been triggered; wait one minute and repeat the ignition operation. * The pilot flame may not be touching the thermocouple due to a partially clogged pilot orifice or low gas pressure; wait one minute and repeat the ignition operation. * The thermocouple could be damaged or its connection to the gas control valve might be loose. In the case of damage to components, it is recommended to contact an authorized service technician. If the connection is loose, hand-tighten it until snug, then tig...
System that shuts off the heater if oxygen levels drop.
One-touch electronic ignitor requiring a battery.
Shuts off gas supply if the flame extinguishes.
Turns off the heater if it's tilted or knocked over.
Crucial warnings regarding gas connection, water damage, and flammable materials.
Steps to take if a gas smell is detected, emphasizing safety.
Warnings about installation in specific states and indoor LPG cylinder use.
Information on CO poisoning symptoms and immediate actions to take.
Emphasizes proper installation, servicing, and socket connection.
Lists areas and conditions where the heater must not be used.
Details dimensions, weight, gas types, model numbers, and pressure ratings.
Emphasizes the need for fresh air for proper operation and safety.
Details on 'unusually tight construction', 'unconfined space', and 'confined space' for ventilation.
Lists specific areas where the heater must not be installed due to safety concerns.
Cautionary advice for installing the heater in a garage to prevent damage.
Steps for unpacking, checking for damage, and verifying hose assembly.
Instructions for connecting the gas hose and testing for leaks.
Step-by-step guide to lighting the heater, including pilot ignition.
How to select heating levels and turn the heater off.
Guide to inspecting pilot and burner flames for correct patterns.
Warning about yellow tipping indicating potential carbon monoxide production.
Recommended checks before first use after extended periods.
Advice on yearly checks, hose replacement, and part sourcing.
Details the 12-month warranty and the conditions for claims.
Outlines how to claim warranty and legal consumer guarantees.
Stresses room ventilation and maintaining safe clearances around the heater.
Key safety advice including supervising children and avoiding misuse.
General| Brand | Bromic Heating |
|---|---|
| Model | SUPAHEAT II |
| Category | Heater |
| Language | English |
To Next Page