EasyManua.ls Logo

Bromic Heating SUPAHEAT II - Table of Contents

Bromic Heating SUPAHEAT II
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Part No. COMP731-1 (LPG)
& COMP732-1 (Natural Gas)
PLUMBING & GAS
Supaheat II - Instruction Manual
2
08 March 2016 - V2
CONTENTS
THE CORRECT GAS MUST BE USED!
1. Product Features & Parts 03
2. Safety Information 04
3. General Warnings 05
4. Technical Specifications 06
5. Installation Requirements 07
6. Installation Instructions 08
7. Operating instructions 09
8. Maintenance
9. Troubleshooting
10. Warranty
11. Important Points
11
12
13
14
Confirm required gas type by checking the markings on the back of
the appliance. This should indicate either Natural Gas or LPG (Propane
Gas). Make sure the gas supply is the same as the gas type marking. If
the gas type is incorrect for any reason, contact your place of purchase.
Code: COMP732-1
Code: COMP731-1
NATURAL GAS
ONLY FOR USE WITH
DO NOT REMOVE THIS LABEL UNTIL THE APPLIANCE HAS BEEN INSTALLED
AND TESTED. TO BE INSTALLED ONLY BY AN AUTHORISED PERSON.
PROPANE GAS
ONLY FOR USE WITH
DO NOT REMOVE LABEL UNTIL THE APPLIANCE HAS BEEN INSTALLED
AND TESTED. TO BE INSTALLED ONLY BY AN AUTHORISED PERSON
PROPANE GAS
ONLY FOR USE WITH
DO NOT REMOVE LABEL UNTIL THE APPLIANCE HAS BEEN INSTALLED
AND TESTED. TO BE INSTALLED ONLY BY AN AUTHORISED PERSON
Room volume must be a minimum of 105 cubic metres
(Note: this is typically a room size of approx. 8m x 6m x 2.4m ceiling height).
WARNING:
!
IMPORTANT:
!
A