Need help?Do you have a question about the brondell FreshSpa Comfort+ and is the answer not in the manual?
General| Type | Bidet seat |
|---|---|
| Water Temperature Control | Yes |
| Nozzle Position Adjustment | Yes |
| Self-Cleaning Nozzle | Yes |
| Nozzle Material | Stainless Steel |
| Spray Width Adjustment | Yes |
| Material | Plastic |
| Color | White |
| Heated Seat | Yes |
| Remote Control | Yes |
| Voltage | 120V |
| Installation | Easy, DIY |
| Power Source | AC power |
The main bidet seat attachment for the toilet.
Brackets used to secure the bidet attachment to the toilet seat.
T-valve connector for cold water supply, typically 7/8" x 7/8" x 3/8".
Flexible hose for connecting the cold water supply to the bidet.
Sealing washers, usually two, for ensuring leak-free connections.
Sealing tape used on threaded connections to prevent leaks.
Verify water supply line compatibility and consider replacing rigid pipes with flexible hoses.
Remove existing toilet seat by loosening mounting bolts and screws.
Turn off water supply, flush toilet, and disconnect the water supply hose from the tank.
Install the cold water T-valve with rubber washers to the toilet tank's incoming water connection.
Connect the cold water braided metal hose to the open side of the installed T-valve.
Place bidet attachment on toilet, align mounting brackets with holes, and secure.
Connect the bidet hose to the cold water inlet on the bidet attachment.
Slowly turn on the main water supply and check all connections for leaks.
Turn dial counterclockwise to the "FRONT" zone for front wash; pressure adjusts with dial position.
Turn dial clockwise to the "REAR" zone for rear wash; pressure adjusts with dial position.
Turn dial to "Nozzle Cleaning" position to wash over the nozzles.
To Next Page
