Brookfield TC-250MX User Manual

TC-Series Circulating Baths with
MX Temperature Controller
!"#$%&'$()*+%,-%.*
//01203*456758****09:/2:/;*
Models:
<=1/20+>*
<=1;20+>*
<=1?20+>*
<=1220+>*
<=1@20+>*
<=1320+>*

Brookfield TC-250MX Specifications

General

Temperature Accuracy	±0.1°C
Temperature Stability	±0.01°C
Input Type	RTD
Output Type	Relay
Communication Interface	RS-232
Heater Power	1000 W
Control Type	PID
Display Type	Digital
Cooling Power	N/A (Cooling via external source)

Summary

Performance Specifications

General Safety Information

Controls and Components

MX Controller

Identifies and labels the components of the MX controller display and buttons.

Quick-Start

Installation and Startup

General Site Requirements

Adding Liquid to the Bath Reservoir

Instructions on filling the reservoir, including maximum and minimum liquid levels.

Controller Setup

Safety Set Temperature

Procedure for setting the user-adjustable safety thermostat to prevent over-temperature conditions.

Normal Operation

Keys and Controls

Set-Up Sub-Menus

Adjusting the Temperature Set Point

Instructions on how to change the desired operating temperature for the bath.

Setting the Offset Calibration

Setting the Low Limit Temperature

Setting the High Limit Temperature

Adjusting the Auto Cool Temperature

Resetting the Factory Default Values

Display Messages and Alarms

Routine Maintenance and Troubleshooting

Draining the Bath Reservoir

Troubleshooting Chart