Brookfield TC-550MX User Manual

TC-Series Circulating Baths with
MX Temperature Controller
!"#$%&'$()*+%,-%.*
//01203*456758****09:/2:/;*
Models:
<=1/20+>*
<=1;20+>*
<=1?20+>*
<=1220+>*
<=1@20+>*
<=1320+>*

Brookfield TC-550MX Specifications

General

Temperature Accuracy	±0.1°C
Temperature Stability	±0.01°C
Display Type	LCD
Power Supply	100-240 VAC, 50/60 Hz
Control Type	PID
Input Type	RTD
Output Type	Relay
Sensor Type	PT100
Communication	RS-232
Probe Type	Immersion
Communication Interface	RS-232

Summary

Performance Specifications of Circulating Baths

General Safety Information for Circulator Use

Safety Recommendations for Circulator Operation

Controls and Components Overview

Quick-Start Guide for Circulator Setup

Installation and Startup Procedures

General Site Requirements

Guidelines for selecting an appropriate location for the circulator.

Adding Liquid to the Bath Reservoir

Instructions for filling the bath reservoir with the correct fluid.

External Closed Loop Circulation Setup

Electrical Power Connection Guide

Controller Setup and Calibration

Safety Set Temperature Configuration

Procedure for setting the over-temperature safety limit.

Normal Operation of the Circulator

Keys and Controls Explained

Main Operational Display Overview

Set-Up Sub-Menus Introduction

Adjusting the Temperature Set Point

How to set the desired operating temperature for the bath.

Selecting the Temperature Unit

Setting the Offset Calibration

Setting the Low Limit Temperature

Setting the High Limit Temperature

Adjusting the Auto Cool Temperature

Resetting the Factory Default Values

Loss of Power Restart Behavior

Display Messages and Alarms Reference

Routine Maintenance and Troubleshooting

Draining the Bath Reservoir

Checking the Over-Temperature Safety System

Cleaning Your Circulator

Troubleshooting Chart for Circulator Issues

Technical Information: Reservoir Fluids

Warranty Repair and Service Information