5
locaTIon of conTRols
1. HEATING LIGHT
2. ON/OFF
3. HOT SURFACE
CAUTION LIGHT
PRePaRInG ToWel
WaRMeR foR Use
1. Open the cover and remove any contents.
2. Place the
Towel Warmer on a dry, level, hard surface.
3. Insert the Ground Fault Safety Plug into a standard 120V AC outlet.
4. Press the red reset button on the Ground Fault Safety Plug.
This is located on the plug at the end of the power cord.
21 3
To Next Page
Loading...