6
ToWel
WaRMeR oPeRaTIon
SELECTING AND WARMING A TOWEL
Your Towel Warmer will warm two bath sheets measuring approximately 40" x 70".
For best results, use 100% cotton or cotton blend towels.
1. Insert the power cord into an electrical outlet.
2. Open the lid and place your towel inside.
3. Close the lid.
4. Press the ON/OFF button on the front of the unit. The green HEATING LIGHT
will illuminate, indicating the unit is warming your towel.
NOTE: The red HOT SURFACE CAUTION LIGHT light will eventually
illuminate, indicating that the inside surfaces of the Towel Warmer are hot to
the touch. Handle the Towel Warmer carefully when the red HOT SURFACE
CAUTION LIGHT
is illuminated.
5. The green HEATING LIGHT will go off after approximately 10 minutes, indicating
that the internal heater has automatically switched off. You may use your towel at
this time, or leave your towel in the warmer for up to 20 minutes before using.
6. To turn the unit off before it is done warming, press the ON/OFF button.
NOTE: The Towel Warmer must cool down, and the red HOT SURFACE
CAUTION LIGHT must go off, for the
Towel Warmer to be used to heat
additional towels.
647156_INS_Towel Warmer_Size:5”Wx4.75”H_Output:100%_Prints:1/1,Blk
To Next Page
Loading...