Skip to Start - Moves the cursor to time 0. If you press “Play”
at this point, your project will play from the beginning.
Play - Starts playing audio at the cursor position. If only some audio
is selected, only the selection is played.
Loop
- If you hold down the shift key, the “Play” button changes
to a “Loop” button, which lets you keep playing the selection over
and over again.
Record
- Starts recording audio at the project sample rate (the sample
rate in the lower-left corner of the window). The new track will begin
at the current cursor position, so click the “Skip to Start” button first
if you want the track to begin at time 0.
Pause - Temporarily stops playback or recording until you press
“Pause” again.
Stop - Stops recording or playing. You must use the “Stop” button
before applying effects, saving or exporting.
Skip to End - Moves the cursor to the end of the last track.
AUDIO CONTROL BUTTONS
16
To Next Page
Loading...