New Stereo Track - Creates a stereo track (similar to above). You can also
create a Stereo Track by joining two tracks using the Track Pop-Down Menu.
New Label Track
- Creates a new Label Track, which can be very useful for
textual annotation.
New Time Track
- Creates a new Time Track, which is used to vary the speed
of playback over time.
Remove Tracks - Removes the selected track or tracks from the project. Even if only
part of a track is selected, the entire track is removed. You can also delete a track by
clicking the X in its upper-left corner. To cut out only part of the audio in a track, use
“Delete” or “Silence”.
Align Tracks
- All of the Align functions work on whole tracks or groups of tracks,
not on selections, even if they span across multiple tracks. They all operate by time-
shifting tracks (moving them left or right), making it easier to synchronize tracks or
get rid of silence at the beginning. The cursor or selection stays in the same place
unless you use the “Align and Move Cursor” command below:
Align and Move Cursor
- Same as the functions above, except that the cursor or
selection is moved along with the tracks, allowing you to shift the tracks without
losing your relative place.
Add Label at Selection - Creates a new label at the current selection. You can title
the label by typing with the keyboard and then hitting “Enter” when you’re done.
Add Label at Playback Position
- Creates a new label at the current location where
you are playing or recording. Use this command if you want to mark a certain passage
while you’re listening to it. You can title the label by typing with the keyboard and then
hitting “Enter” or “Return” when you’re done. Only available while Audacity is playing.
28
To Next Page
Loading...