6
CONNECTING ThE sCaNNER TO ThE COMPUTER
Plug the ends of the USB cable into the scanner and into your computer,
or a port on a USB hub.
INsTallING ThE sOfTWaRE
Your computer will automatically detect the scanner when you connect it, and
“Add New Hardware Wizard” or “Found New Hardware Wizard” will be launched.
Click on the “Next” button when “Add New Hardware Wizard” window
is displayed.
Select “Search for the Best Driver for your Device (Recommended)”
and click on the “Next” button.
The next window will ask you where to search to find the drive.
Select “CD-ROM Drive”, and deselect “Floppy Disk Drives” if it is checked.
Insert the Setup/Application CD-ROM, included with your scanner,
into your CD-ROM drive and then click on the “Next” button.
Please skip to FINISHING THE INSTALL at this time.
During the process of installation, a message “Digital Signature
Required” may appear on-screen. Please ignore it and click on “Yes” to continue the
installation and then go to the FINISHING THE INSTALL section on page 8.
•
•
•
•
To Next Page
Loading...
