Brookstone IDESIGN - Initial Setup and Connections; Connecting the Unit

OPERATION
TURNING THE UNIT ON/STANDBY
Switch the MAIN POWER SWITCH on the back of the unit to ON.
Press
on top of the tower or on the remote to turn the unit on.
The blue POWER LED will illuminate.
Press again to put the unit into STANDBY mode.
Note: Your iPod/iPhone will charge while it is docked in the unit
in Power On and in Stand-by Mode.
TURNING OFF THE UNIT
Switch the MAIN POWER SWITCH on the back of the unit to OFF.
CONNECTING YOUR iPod/iPhone TO THE UNIT
1. Select the correct iPod/iPhone DOCK ADAPTER for your device from
the following list, or use the one that came with your iPod/iPhone,
and snap it securely into the docking area on the top of the unit.
iPod/iPhone DOCK ADAPTERS included are as follows:
Insert A: iPod classic (160GB (2009), 120GB, 80GB)
Insert B: iPod nano (4th Gen)
Insert C: iPod nano (5th Gen)
Insert D: iPod touch (2nd Gen)
Insert E: iPhone (3G/3GS)
2. Insert your iPod/iPhone into the dock.
1.
2.
3.
13