10
KNOWING YOUR SEWING MACHINE
This section describes how to wind the thread onto the
bobbin.
• For details on the fast bobbin winding, see page 12.
a
Press down on the spool pin lever to swing up
the spool pin. Then remove the spool cap.
a Spool pin
b Spool cap
b
Fully insert the spool of thread for the bobbin,
and then slide the spool cap onto the spool pin.
• The thread should be unwound from the
bottom to the front.
● When sewing with fine, cross-wound thread, use
the small spool cap, and leave a small space
between the cap and the spool.
THREADING THE MACHINE
Winding the bobbin
CAUTION
● Only use bobbins (part code: SA156, SFB:
XA5539-151) that have been designed for this
sewing machine. Using other bobbins may cause
damage to the machine.
● We designed the bobbin that comes with this
machine. If you use bobbins from other models,
the machine will not work properly. Only use
the bobbin that comes with this machine or
bobbins of the same type (part code: SA156,
SFB: XA5539-151).
a Bobbin-winding thread guide
b Bobbin winder shaft
c Bobbin
Actual size
This model Other models
11.5 mm
(7/16 inch)
CAUTION
● Do not grab the bar to raise the spool pin,
otherwise, the spool pin may bend or break.
● Be sure to raise the spool pin when winding the
bobbin. The thread may become tangled if the
bobbin winder is used without raising the spool
pin.
CAUTION
● If the spool or the spool cap is not positioned
correctly, the thread may become tangled
around the spool pin or the machine may be
damaged.
● Three spool cap sizes are available, allowing
you to choose a spool cap that best fits the size
of spool being used. If the spool cap is too small
for the spool being used, the thread may catch
on the slit in the spool or the machine may be
damaged.
a Spool cap (small)
b Spool
(cross-wound thread)
c Space
To Next Page
Loading...
