Why is thread unravelling at the sewing start on my Brother Sewing Machine?
If thread is unravelling at the sewing start on your Brother Sewing Machine, it may be because the rotary hook pulls the upper thread. To solve this, use the programmer to reduce the intermittent presser foot height so that the upper thread is pressed by the intermittent presser foot at the 1st stitch.
How to prevent my Brother BAS-326G PS Sewing Machine needle from breaking?
To prevent your Brother Sewing Machine needle from breaking, check these points: * If the clearance between the needle and rotary hook tip is too great, adjust the needle clearance. * If the needle is bent, replace it. * Needle deflection can cause breakage, so select a needle suitable for the sewing conditions and reduce the sewing speed. * If the needle is too thin, select a needle suitable for the sewing conditions.
Why is the thread tightening incorrectly on my Brother BAS-326G PS?
If the thread is tightening incorrectly on your Brother Sewing Machine, it could be due to: * Upper thread tension being too weak: Adjust the upper thread tension. * Lower thread tension being too weak: Adjust the lower thread tension. * Thread take-up spring tension and height being incorrect: Adjust the tension and height of the thread take-up spring. * Position of arm thread guide R being incorrect: Adjust the position of arm thread guide R. * Intermittent height of intermittent presser foot being too low: Adjust the intermittent height of the intermittent presser foot.
How to fix thread jamming in my Brother Sewing Machine?
If the thread is jamming in your Brother Sewing Machine, consider these potential causes: * The thread take-up spring tension and height are incorrect, so adjust them. * The needle and rotary hook timing is incorrect, so adjust the needle bar lift amount.
What causes the lower thread to break on a Brother BAS-326G PS?
The lower thread on your Brother Sewing Machine may break if: * The lower thread tension is too strong: Adjust the lower thread tension. * There is damage to the needle hole plate or bobbin case: Repair or replace the problem part.
What to do if the thread slips out of the needle on my Brother BAS-326G PS?
If the thread slips out of the needle on your Brother Sewing Machine: * If stitches are being skipped at the sewing start, refer to "Skipped stitches occur". * If the upper thread trailing length is uneven, adjust the sub tension.
What to do if the work clamp does not lift to the maximum height on my Brother BAS-326G PS Sewing Machine?
If the work clamp on your Brother Sewing Machine does not lift to the maximum height, adjust the position of the cylinder joint, as it is likely incorrect.
What causes the work clamp to not lift or drop on my Brother BAS-326G PS?
If the work clamp on your Brother Sewing Machine is not lifting or dropping, it could be due to: * The work clamp moving stiffly: Apply a suitable amount of grease to the sliding parts of the work clamp. * The air tube of the air cylinder being bent or damaged: Straighten the bend in the tube or replace the tube.
What to do if thread wiper does not operate correctly on Brother Sewing Machine?
If the thread wiper on your Brother Sewing Machine isn't operating correctly: * If the thread wiper is obstructing the needle, adjust the height of the thread wiper. * If the thread wiper position is incorrect, adjust the stroke of the thread wiper.
What causes the hitch stitch sewing range to be too great on my Brother Sewing Machine?
If the hitch stitch sewing range is too great on your Brother Sewing Machine, consider the following: * Lower thread tension is too weak: Adjust the lower thread tension. * Lower thread is threaded incorrectly: Pass the lower thread through the window of the inner rotary hook. * Sewing speed is too high: Reduce the sewing speed. * Needle is incorrectly installed: Install the needle correctly.
General| Brand | Brother |
|---|---|
| Model | BAS-326G PS |
| Category | Sewing Machine |
| Language | English |
To Next Page
