4
DO NOT put the product in a location that blocks or obstructs any slot or opening in the product.
These slots and openings are provided for ventilation. Blocking the product’s ventilation could
create a risk of overheating and/or fire.
Instead:
• Keep a gap of at least 100 mm between the ventilation hole and the wall.
• Place the product on a solid level surface.
• DO NOT place this product near or over a radiator or heater.
• DO NOT place this product in a “built-in” installation unless adequate ventilation is provided.
Keep a minimum gap around the machine as shown in the illustration.
(HL only)
(MFC and DCP only)
100 mm 250 mm100 mm
200 mm
100 mm 250 mm100 mm
400 mm
To Next Page
Loading...
Need help?
General
