2-14
Confidential
Error
codes
Description
Refer
to:
Error
codes
Description
Refer
to:
6902
Rechecking the error after the power
switch was turned OFF and then ON
again because an error was detected
in the fuser unit. (This message is
displayed for approximately 15
minutes when the machine is
restarted after error code 6901 has
occurred.)
2-54 7100
The eject sensor remains ON (paper
pass detected) even after the
registration rear sensor detected the
end of paper pass.
2-56
6A00
Detected discharge that may be
attributable to dirty corona wire on the
drum unit.
2-54
7101 ―
6B01 ― 7102 ―
6B02 ― 7103 ―
6B03 ― 7104 ―
6B04 ― 7105 ―
6B0A ― 7106 ―
6C01 ― 7200
When feeding from the MP tray, the
registration rear sensor does not
detect paper pass within the specified
time after the registration front sensor
detected paper pass.
2-56
6C02 ― 7201 ―
6C03 ― 7300 ―
6C04 ― 7301
When printing from the paper tray 1,
the T1 paper feed sensor does not
detect paper pass within the specified
time while the T1 paper empty sensor
detects some paper set.
2-57
6D00
Detected more LTs than connectible
limit.
2-55 7302
When printing from the paper tray 1,
the registration front sensor does not
detect paper pass within the specified
time after the T1 paper feed sensor
detected paper pass.
2-57
6E00 ― 7400 ―
6F00
Detected irregular power supply for
less than 100 times.
2-55 7401
When printing from the paper tray 2, the
T2(LT or TT) paper feed sensor does not
detect paper pass within the specified
time while the T2(LT or TT) paper empty
sensor detects some paper set.
2-58
7000
The eject sensor does not detect
paper pass after the registration rear
sensor detected the paper pass.
2-55 7402
When printing from the paper tray 2,
the registration front sensor or the
T2TT jam sensor does not detect
paper pass within the specified time
after the T2(LT or TT) paper feed
sensor detected paper pass.
2-59
7001 ― 7500 ―
7002 ― 7501
When printing from the paper tray 3, the
T3(LT or TT) paper feed sensor does not
detect paper pass within the specified
time while the T3(LT or TT) paper empty
sensor detects some paper set.
2-60
7003 ― 7502
When printing from the paper tray 3,
the registration front sensor or the T2/
T3TT jam sensor does not detect
paper pass within the specified time
after the T3(LT or TT) paper feed
sensor detected paper pass.
2-61
7004 ― 7601
When printing from the paper tray 4, the
T4(LT or TT) paper feed sensor does not
detect paper pass within the specified
time while the T4(LT or TT) paper empty
sensor detects some paper set.
2-62
To Next Page
Loading...
Need help?
General
Weight and Dimensions
