Brother MFC-L2712DN - Page 85


Common to all models
(11)
Remove the T
aptite bind B M4x12 (11a) screw (for securing the Under bar), the Taptite cup
S M3x6 SR (11b) screw (for securing the Chu
te ground plate), the Taptite bind B M4x12
(1
1c) screw (for securing the
Registration chute), and the
T
aptite cup S M3x8 S
R (11d)
screw (for securing the Laser L FG plate).
(12)
Remove the two Tap
tite bind B M4x12 (12a)
screws and the tw
o T
aptite cup S M3x8
SR (12b)
screws, and remove the Frame L unit. Pull out the Paper feed sensor harness, the Cartridge
sensor harness (only for models without Toner box) and the LVPS harness from the Holes.
Fig. 3-91
Harness routing: Refer to
“
10
.
Frame L unit (Manual feed models)
”
.
Assembling Note:
•
When assem
bling the Fra
me L unit, make sur
e that the Chute gro
und plate is ab
ove
the Main PCB FG plate 2.
Taptite cup S M3x8 SR (11d)
Taptite cup S M3x8 SR (12b)
Taptite bind B
M4x12 (12a)
Frame L unit
Taptite bind B M4x12 (11c)
Registration chute
Taptite cup S M3x6 SR (11b)
Chute ground plate
Taptite bind B M4x12 (11a)
Under bar
Registration chute
12b
Laser L FG plate
11d
12a
12b
<Upper side of Frame L>
Main PCB FG
plate 2
Holes
Hole
Paper feed sensor
harness
LVPS
harness
Holes
Hole
<Bottom side>
<Overhead view
of Frame L>
Cartridge sensor harness
(Only for models without Toner box)