Brother MFC-L2712DN - Page 86

9.31
Paper feed mo
tor / Paper feed mo
tor flat cable
(1)
Relea
se the Paper f
eed moto
r flat cable a
nd the Fron
t cover sen
sor harne
ss from the
securing fixtures.
(2)
Remov
e the T
aptite bi
nd B M4x12 screw
. Release th
e Hook, and slid
e the Flat cable gui
de
in the direction of the arrow to remove it from the Motor drive sub ASSY.
(3)
Remov
e the Screw
pan (S/P w
asher)
M3x12DB
, and rem
ove the La
ser L FG pl
ate from
the
Motor drive
sub ASSY.
(4)
Remov
e the three T
aptite bin
d B M4x12 screws and the T
aptite cup S M3x8 SR scre
w, and
remove the Motor drive sub ASSY from the Frame L unit.
Fig. 3-92
Harness routing: Refer to
“
10
.
Frame L unit (Manual feed models)
”
.
Assembling Note:
•
Be caref
ul not to
bend th
e Laser L
FG plate
.
•
Attach th
e Motor drive su
b ASSY to the Frame L unit whil
e the Develo
p joint link is
pushed. Pull the Develop joint link back before tightening the screws for
the Motor drive
sub ASSY. Failure to follow the procedure above may get the Develop joint link caught
and jammed.
Screw pan (S/P washer)
M3x12DB
Flat cable guide
Laser L FG plate
Taptite bind B M4x12
Motor drive sub ASSY
Hook
Taptite bind B M4x12
Taptite bind B M4x12
Frame L unit
Develop joint link
Taptite cup S M3x8 SR
Front cover sensor harness
Paper feed motor flat cable