Brother MFC-L2712DN - Page 89

9.33
T
oner sensor PCB AS
SY
(Only for models
with Tone
r box)
(1)
Relea
se the T
oner box soleno
id harness and the T
oner sensor har
ness from the securi
ng
fixtures.
(2)
Remov
e the two T
aptite bind B M4x12 scr
ews. Rele
ase the Hook to remove the T
oner box
drive cover from the F
rame L unit. Pull out
the T
oner sensor harness from
the Hole.
(3)
Slide the Dev
elop joi
nt link in the direc
tion of the arrow
. Remove the Dev
elop join
t disk from
the Develop joint lift cover. Release the Hook of the Develop joint link to remove the
Develop joint lift cover.
(4)
Remov
e the D
evelop
joint
link f
rom the
Frame L
unit.
(5)
Remov
e the T
aptite bi
nd B M3x8 screw to remo
ve the Film and the T
oner senso
r PCB
ASSY
.
Fig. 3-96
Harness routing: Refer to
“
10
.
Frame L unit (Manual feed models)
”
.
Taptite bind B M3x8
Taptite bind B M4x12
Hole
Develop joint disk
Develop joint lift cover
Film
Toner sensor PCB ASSY
Toner sensor
harness
Toner box solenoid harness
Develop joint lift cover
Hook
Develop joint link
Toner box drive cover
Hook
Frame L unit