Brother MFC-L2712DN - Page 91

9.35
Eject sen
sor PC
B ASSY
(1)
Remov
e the T
aptite c
up S M3x8 SR scr
ew and the Sc
rew pan (
S/P washe
r) M3x12D
B
screw. Lift the upper side of the Main shield plate up to remove it from the Pin, and pull out
the Main shield plate in the direction of the arrow to remove it from the Rib of the Frame L
unit.
Fig. 3-98
Assembling Note:
•
When assem
bling the Ma
in shield pl
ate, check tha
t the Main PCB ground sp
ring is not
inclined. Attach it correctly as shown in the figure above.
•
If you removed th
e Main shield pla
te while the Fuse
r unit was attac
hed on the machine
,
release the Side thermistor harness ASSY and the Center thermistor harness ASSY
from the securing fixture of the Frame L unit. Then tighten the screw for the Main shield
plate and secure each harness in the securing fixture. If the Main shield plate is
assembled while the Fuser unit is attached to
the machine, the Side thermistor harness
ASSY and the Center thermistor harness AS
SY may be caught.
Screw pan (S/P washer)
M3x12DB
Main shield plate
Taptite cup S M3x8 SR
Frame L unit
Main PCB ground spring
Main shield plate
Rib
Pin