Brother MFC-L2712DN - Page 93

9.369.36
RegistrRegistr
ation front/ation front/
rear actuator holderear actuator holde
r ASSYr ASSY
(1)(1)
ReleaRelea
se the Hook pse the Hook p
art of the Unart of the Un
der R FG wirder R FG wir
e from the Le from the L
VPS shielVPS shiel
d plate.d plate.
(2)(2)
Raise Raise
the Lasethe Lase
r R FG plr R FG pl
ate sliate sli
ghtly tghtly t
o removo remov
e it froe it fro
m the Pinm the Pin
..
(3)(3)
RemovRemov
e the Te the T
aptite cuaptite cu
p S M3x8 SR screw and thp S M3x8 SR screw and th
e Te T
aptite binaptite bin
d B M4x12 screwd B M4x12 screw
, pull out the, pull out the
right side of the LVPS shield plate in the direction of the arrow A to remove it from the Pin.right side of the LVPS shield plate in the direction of the arrow A to remove it from the Pin.
And then pull it out in the direction of the arrow B to remove it from the machine.And then pull it out in the direction of the arrow B to remove it from the machine.
Fig. 3-100Fig. 3-100
Note:Note:
••
As the UndAs the Und
er bar is easer bar is eas
y to bend, by to bend, b
e careful te careful t
o handle ito handle it
..
Under R FG wireUnder R FG wire
Taptite cup STaptite cup S
M3x8 SRM3x8 SR
LVPS shieldLVPS shield
plateplate
Taptite bind BTaptite bind B
M4x12M4x12
Laser R FG plateLaser R FG plate
Hook partHook part
<Back side><Back side>
<Rear view of<Rear view of
Frame R>Frame R>
AA
BB
Under barUnder bar
<Bottom side><Bottom side>
PinPin
LVPS shield plateLVPS shield plate