Brother MFC-L2712DN - Page 94

(4)(4)
Release thRelease th
e Registrate Registrat
ion front/ion front/
rear sensorear senso
r harness and the Lr harness and the L
VPS harness from thVPS harness from th
e securinge securing
fixtures.fixtures.
(5)(5)
RemovRemov
e the Te the T
aptite cup S M3xaptite cup S M3x
6 SR screw and the two T6 SR screw and the two T
aptite biaptite bi
nd B M4x12 screwnd B M4x12 screw
s tos to
remove the Frame R unit. Pull out the Registration front/rear sensor harness from the Hole.remove the Frame R unit. Pull out the Registration front/rear sensor harness from the Hole.
Fig. 3-101Fig. 3-101
Harness routing: Refer toHarness routing: Refer to
““
1212
..
TT
op side of op side of
the registration chutethe registration chute
””
,,
““
1313
..
Frame R unitFrame R unit
””
..
Assembling Note:Assembling Note:
••
When attaWhen atta
ching the Fraching the Fra
me R unit, checme R unit, chec
k that the Lk that the L
VPS FG plate is set to the FraVPS FG plate is set to the Fra
me Rme R
unit.unit.
Taptite cup S M3x6 SRTaptite cup S M3x6 SR
<Overhead view<Overhead view
of Frame R>of Frame R>
LVPS FG plateLVPS FG plate
HoleHole
Registration front/rear sensor harnessRegistration front/rear sensor harness
Frame R unitFrame R unit
Taptite bind B M4x12Taptite bind B M4x12
HoleHole
Taptite bind B M4x12Taptite bind B M4x12
<Front side><Front side>
LVPSLVPS
harnessharness
<Bottom side><Bottom side>