Brother MFC-L2712DN - Page 95

(6)(6)
RemovRemov
e the Te the T
aptite biaptite bi
nd B M3x10 screwnd B M3x10 screw
. Release eac. Release eac
h Hook, and removh Hook, and remov
e the Registe the Regist
rationration
front/rear actuator holder ASSY from the Registration chute. Pull out the Registration front/front/rear actuator holder ASSY from the Registration chute. Pull out the Registration front/
rear sensor harness from the Hole.rear sensor harness from the Hole.
Fig. 3-102Fig. 3-102
Harness routing: Refer toHarness routing: Refer to
““
1212
..
TT
op side of op side of
the registration chutethe registration chute
””
..
Fig. 3-103Fig. 3-103
Assembling Note:Assembling Note:
••
After asseAfter asse
mbling the Regimbling the Regi
stratiostratio
n front/rean front/rea
r actuator holdr actuator hold
er ASSY to the Registratioer ASSY to the Registratio
nn
chute, push the Actuators by fingers and check if they are pushed back by their springschute, push the Actuators by fingers and check if they are pushed back by their springs
(if the springs are not caught at assembling).(if the springs are not caught at assembling).
Registration front/rear actuatorRegistration front/rear actuator
holder ASSYholder ASSY
Taptite bind B M3x10Taptite bind B M3x10
HooksHooks
HookHook
Registration front/rearRegistration front/rear
sensor harnesssensor harness
HookHook
HoleHole
Registration chuteRegistration chute
<Bottom side><Bottom side>
Registration chuteRegistration chute
ActuatorsActuators
<Top side><Top side>