Need help?Do you have a question about the Brother NV800E and is the answer not in the manual?
General| Built-in Embroidery Designs | 138 |
|---|---|
| USB Port | Yes |
| LCD Display | Yes |
| Needle Threader | Automatic |
| Built-in Embroidery Fonts | 11 |
| Display Screen | LCD Touchscreen |
| Presser Feet | Embroidery foot |
| Embroidery Area | 160mm x 260mm |
| Maximum Embroidery Speed | 850 spm |
| Type | Embroidery Machine |
| Bobbin | Drop-in |
| Dimensions | 240mm |
Please read these safety instructions before attempting to use the machine.
This section provides details on the initial setup procedures as well as descriptions of this machine's more useful functions.
This section provides instruction on editing embroidery patterns and recalling stored embroidery patterns.
This section provides important information for operating this machine.
This section provides details on the initial setup procedures as well as descriptions of this machine's more useful functions.
To learn how to prepare for embroidering and basic embroidering operations.
The names of the various parts of the machine and their functions are described below.
Use only regular household electricity for the power source. Using other power sources may result in fire, electric shock, or damage to the machine.
This section describes how to wind thread onto a bobbin.
Carefully follow the instructions. If the upper threading is not correct, the thread may become tangled or the needle may bend or break.
Be sure to observe the following precautions concerning the handling of the needle. Failure to observe these precautions is extremely dangerous.
Follow the steps below to prepare the machine for embroidery.
Use fabrics with a thickness of less than 3 mm. Adjusting the presser foot height may be necessary for thick or puffy fabrics.
Select a simple pattern built-in your machine and embroider for testing purposes. You can try various selection of patterns and pattern editing.
Embroidery patterns are embroidered with a change of thread after each color. Prepare embroidery thread of the color shown on the screen.
This section provides instruction to embroider designs with this machine. Screen display and machine illustration may vary slightly.
Prepare the machine for embroidery according to the instructions on 'STARTING TO EMBROIDER' of 'Basic operations'.
When a pattern is selected in the pattern selection screen and Set is pressed, the pattern editing screen appears.
Use the arrow keys to move the pattern in the direction shown by the arrow. Press the center key to center the pattern.
Select the direction in which to change the size. Enlarge, shrink, stretch, or compact the pattern shape.
Select the angle of rotation for the pattern. Rotate the pattern 1, 10, or 90 degrees.
When the bobbin begins to run out of thread during embroidering, the machine will stop and a message will appear.
When embroidering, the thread tension should be set so that the upper thread can slightly be seen on the wrong side of the fabric.
This section provides important information for operating this machine. Find troubleshooting tips and pointers.
In order to prevent damaging this machine, it must not be oiled by the user. Clean the machine surface and race regularly.
Check the following possible problems before requesting service. You can solve most problems by yourself.
When erroneous operations are performed, messages and advice on operation will be displayed on the LCD. Follow what is displayed.
To Next Page
