Brother NV800E - Chapter 2 STARTING TO EMBROIDER; Embroidery Step by Step

Embroidery Step by Step
Basic operations B-25
STARTING TO EMBROIDER
B
Follow the steps below to prepare the machine for embroidery.
Chapter 2
STARTING TO
EMBROIDER
Embroidery Step by Step
Step 2
Step 1
Step 4
Step 5
Step 3
Step 6, 7
Step 8
Step # Aim Action Page
1 Checking the needle Use needle 75/11 for embroidery. * B-23
2 Embroidery unit attachment Attach the embroidery unit. B-26
3 Bobbin thread setup For the bobbin thread, wind embroidery bobbin thread and set it in place. B-17
4 Fabric preparation Attach a stabilizer material to the fabric, and hoop it in the embroidery frame. B-29
5 Embroidery frame attachment Attach the embroidery frame to the embroidery unit. B-35
6 Pattern selection Turn the main power to on, and select an embroidery pattern. B-9
7 Checking the layout Check and adjust the size and position of the embroidery. B-35
8 Embroidery thread setup Set up embroidery thread according to the pattern. B-28
* It is recommended that a 90/14 needle should be used when embroidering on heavy weight fabrics or stabilizing products (for example;
denim, puffy foam, etc.).