25
THE TEN COMMANDMENTS OF OPERATION
NEVER - Operate this or any other equipment without reading and 1.
understanding the owners manual.
NEVER – Attach this product to a tractor that does not have suitable safety 2.
equipment properly installed .
NEVER – Operate this equipment without all safety equipment properly 3.
installed on this equipment.
NEVER – Start the cutting process without inspecting, walking, agging or 4.
removing all foreign material from job site.
NEVER – Allow any riders or bystanders within 300 feet of this unit 5.
during operation.
NEVER – Operate this equipment until bolts, fasteners, ttings and oil 6.
levels have been checked for operational status.
NEVER – Allow blades to make contact with rocks or stumps – unit was 7.
not designed for this type of operation.
NEVER – Allow an untrained operator to operate this equipment.8.
NEVER – Install any parts that are not genuine Brown replacement parts.9.
NEVER – Leave tractor seat until blades have stopped turning and all 10.
tractor shut down procedures have been completed.
THESE ARE ONLY A FEW OF THE SAFETY PROCEDURES THAT MUST BE
FOLLOWED TO INSURE THE SAFE OPERATION OF THIS EQUIPMENT – MANY
OTHER SAFETY RELATED POINTS ARE STATED THROUGHOUT THIS MANUAL
WARNING: FAILURE TO FOLLOW THE TEN COMMANDMENTS
CAN AND WILL CAUSE SERIOUS INJURY OR DEATH
IF YOU HAVE ANY SAFETY, MAINTENANCE OR OPERATIONAL QUESTIONS –
PLEASE CALL BROWN MFG. BEFORE USING THIS EQUIPMENT AT 1-800-633-8909
To Next Page
Loading...
