Remove the operating handle as follows:
With your left hand, push on the bolt head
moving the breechblock about 1/2” back
into the receiver, lining up the operating
handle with the notch at the bottom front
of the ejection port (See Figure 11-A). With
your right hand grasp the operating handle
and pull it outward, removing it from the
breechblock (See Figure 11-B).
The breechblock will now be able to move
forward about another 1/2”. Again, push
rearward on the bolt head, depressing the
breechblock back into the receiver about
1/4”. With your right hand, reach in with a
finger and push on the breechblock lever
37
To Next Page
Loading...