17
FIGURE 16
Remove the rear sight base screw located
behind the rear sight.
FIGURE 17
Loosen the barrel mounting screw.
facility. Do not remove the grips from the pistol, as they serve to
retain and position internal parts.
DISASSEMBLY
FIELD 5.5 & TARGET 5.5 MODELS
Disassembly of the Field 5.5 and Target 5.5 models is identical to the
regular Buck Mark with a few minor exceptions.
1 Remove the rear sight base screw located behind the rear sight
(Figure 16). On Target 5.5 models the sight hood may have to be
removed by inserting your index finger inside the hood and pulling
up and outward on one side of the hood until it comes off. (Replace
in reverse order.)
CAUTION: WHEN REINSTALLING THE REAR SIGHT BASE SCREW, MAKE
CERTAIN TO REPLACE THE LOCKWASHER. ALWAYS USE THE SIGHT BASE
SCREW LOCKWASHER SUPPLIED WITH YOUR PISTOL. IF LOST, ORDER A
NEW LOCKWASHER FROM BROWNING. FAILURE TO USE A BROWNING
SIGHT BASE SCREW LOCKWASHER MAY MAKE IT VERY DIFFICULT TO
REMOVE THE REAR SIGHT BASE SCREW.
2 Loosen the barrel mounting screw — found below the barrel, at
the front of the frame — approximately 3 1/2 turns (Figure 17).
3 To remove the barrel, pull the slide back about 1". Then pivot the
barrel down and lift the barrel off of the frame (Figure 18). Set the
barrel aside.
To Next Page
Loading...