Browning Golden Eagle Mark III User Manual

List of essential test equipment for transmitter servicing.

Initial front panel control settings for alignment.

Steps for idle current, oscillator, and RF power adjustment.

Adjusting carrier oscillators and frequency settings for SSB/AM.

Procedure for balancing the transmitter carrier signal.

Verifying and adjusting sideband frequency tolerance.

Procedure for balancing RF power across the band.

Diagram illustrating the test equipment setup for transmitter alignment.

Basic checks and methods for locating receiver faults.

Procedure for measuring receiver gain across frequency bands.

Steps for aligning the receiver in AM mode.

Further steps for AM receiver alignment, including crystal oscillator checks.

Steps for aligning the receiver in SSB mode.

Alternative method for SSB receiver alignment and balance.

Procedure for balancing lower and upper sideband signals.