20
certain a live cartridge is not present in the chamber. Leave the
bolt in the rearward position with the action open.
3 With the chamber empty and the magazine removed, close
the bolt.
4 If you are finished shooting, strip the cartridges from the
magazine as explained in the next section and insert the empty
magazine into the magazine well of the rifle.
UNLOADING THE MAGAZINE
1 Angle the front of the magazine down.
2 Rotate the gear slightly with your thumb. This releases spring
pressure, allowing the cartridges in the magazine to easily be
removed from the magazine.
MOUNTING A SCOPE
Before mounting a scoPe, sight or other accessories to your
rifle, Place the “safety” in the on safe Position. oPen the
action and maKe certain your rifle is comPletely unloaded.
KeeP the muZZle Pointed in a safe direction. failure to follow
these warnings could result in serious injury or death.
The top of the T-Bolt receiver is drilled and tapped for scope bases.
See your Browning dealer to purchase the scope mount bases and
rings designed for the T-Bolt.
NOTICE! always use the correct Bases for this rifle and the
aPProPriate length screws, or damage could occur to the rifle.
1 Place your rifle in a gun vise or on a table or other safe/secure
location with the top of the receiver upward. Protect the finish
with rags or other padding.
2 Remove the bolt as instructed on page 12.
3 You should have compatible two-piece style bases and four screws
of the correct length.
To Next Page
Loading...